Spool holder for Anycubic

Spool holder for those small spools axle diameter 20mm.

Designed for Anycubic-s spool holders as you can see on the picture.

If you choose to print it in one piece I recommend supports, see picture of support locations that I used and it came out good. I used supports offset of 150% when printing 0,2 layer height, was not very hard to remove.

If you choose to print the 2 piece version, please use both A and B files because of thread. Also you don´t need supports. Don´t worry, when you put those 2 pieces together and turn it to holder, it will be solid and you can use screw normally, it acts like wedge. If you want, you can always super-glue those 2 parts together.

If you like it, don't be afraid to show it ;)