Thingiverse
Spool holder for Creativity ELF printer
door B-Cup
5
Downloads
10
Likes
0
Makes
Frame mounted spool holder for the Creativity ELF printer. Also probably fits the Sapphire printer or any other that uses 2020 framing.
Print two of all the pieces and assemble using 3/4" schedule 40 PVC. I used two 12" pieces for the vertical, and a 20.5" piece for the horizontal. All pieces that bolt to the 2020 use a 4x12mm and a 4x16mm and two T nuts. I drilled a hole through the PVC on each end and there are holes in the top brackets to drop a screw through to hold the pvc in place and make it easy to change filament.
Print two of all the pieces and assemble using 3/4" schedule 40 PVC. I used two 12" pieces for the vertical, and a 20.5" piece for the horizontal. All pieces that bolt to the 2020 use a 4x12mm and a 4x16mm and two T nuts. I drilled a hole through the PVC on each end and there are holes in the top brackets to drop a screw through to hold the pvc in place and make it easy to change filament.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!