Thingiverse
Spool holder for Extrusions
von Morgan0815
3
Downloads
0
Likes
0
Makes
this is for 3030 extrusions maybe other
you need 3x 608 bearings and M4x30
The spool guided by only 3 points looks different but
it works very well and there is no stocking.
Even if the spool rests on 4 bearings they sometimes stock
because the sides interfere with the mount.
the best alternative I used before was to mount it on top, but I alway got trouble
with guiding the filament correctly into the extruder
you need 3x 608 bearings and M4x30
The spool guided by only 3 points looks different but
it works very well and there is no stocking.
Even if the spool rests on 4 bearings they sometimes stock
because the sides interfere with the mount.
the best alternative I used before was to mount it on top, but I alway got trouble
with guiding the filament correctly into the extruder
Morgan0815 veröffentlicht auch auf
7 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
