Thingiverse
Spool holder for Prusa RepRap
von Hackens
0
Downloads
0
Likes
0
Makes
mount as specified in screenshot
The horizontal bars can be either threaded rods or simple rods
The filament holder can be used to hold in place a piece of cloth to clean the filament before it is extruded
You can split the filament holder in two and clamp it around the horizontal rods using the small screw holes. This way you can install/remove the filament holder without unmounting the whole setup each time.
Mount the filament spool on the cylinder, and support it with 22mm ball bearings.
You can install/remove the filament spool without unmounting anything other than spoolholder2.stl
We used an antistatic component holder to apply friction to the spool, otherwise it had way too mush intertia when mounted on ball bearings.
Designed by Guillaume (Mathers) for Hackens (11/2014)
The horizontal bars can be either threaded rods or simple rods
The filament holder can be used to hold in place a piece of cloth to clean the filament before it is extruded
You can split the filament holder in two and clamp it around the horizontal rods using the small screw holes. This way you can install/remove the filament holder without unmounting the whole setup each time.
Mount the filament spool on the cylinder, and support it with 22mm ball bearings.
You can install/remove the filament spool without unmounting anything other than spoolholder2.stl
We used an antistatic component holder to apply friction to the spool, otherwise it had way too mush intertia when mounted on ball bearings.
Designed by Guillaume (Mathers) for Hackens (11/2014)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
