Thingiverse
Spool holder for Tarantula
von obor
11
Downloads
8
Likes
0
Makes
My version of spool holder for tarantula. It should adapt any kind of filament spooler. The threaded shaft can easily be removed for spool replacement.
Need:
- M5x10 screw + nutt
- M8 threaded shatf, length 13 cm
- 2 * M8 nutt
- 2 * bearing 8x7x22
Note that bearings are not mandatory and can be omitted.
Need:
- M5x10 screw + nutt
- M8 threaded shatf, length 13 cm
- 2 * M8 nutt
- 2 * bearing 8x7x22
Note that bearings are not mandatory and can be omitted.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
