Thingiverse
Spool Holder Pipe long
8
Downloads
4
Likes
0
Makes
I made this Spool Holder Pipe for the longest spool mount. ( SpoolHolderUpdate3 )
The new Version has a thicker part on one end to keep the spool from dragging on the nut and possible fall off the holder.
This part is only needed if you have spools that are not smooth on the inside.
Also by using this part you could use fewer bearings if you want to.
I think most of the time two bearings should be enough.
Since I don´t edited the other Parts, they are not includet here.
You can find it at https://www.thingiverse.com/thing:3059893
The new Version has a thicker part on one end to keep the spool from dragging on the nut and possible fall off the holder.
This part is only needed if you have spools that are not smooth on the inside.
Also by using this part you could use fewer bearings if you want to.
I think most of the time two bearings should be enough.
Since I don´t edited the other Parts, they are not includet here.
You can find it at https://www.thingiverse.com/thing:3059893
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
