Spool Holder Scaffold

I really like the Spool Holders named TUSH and use the with my printer a lot. But as the spool holders were always tagged along by the extruder pulling on the filament I tried to clue the spools down on the table with double sided tape. As this is principally working it is also very difficult to arrange the spool holders parallel and aligned. To make this easy I designed this spool holder scaffold, where the two holders of a spool fit nicely for 55mm broad spools and a small single piece of double sides tape on the bottom does the trick for me.

If you need to change the lateral spacing for your filament brand's spools, use the f360 file and change the parameter: *lateralspace* to the width of your spool