Thingiverse
Spool Holder Stand (Ender 3 pro)
por robinrex92
2
Descargas
0
Likes
0
Makes
A simple stand for the stock spool holder, that uses the stock T-nut and screws that come with ender 3 pro! The T nut might be a snug fit in the hole.
I used 15% infill (Grid) and it works well for me. You could increase if you want it to be sturdier and a little heavier.
I printed with 0.2mm layer height, at 75mm/s with combing (within infill) enabled, and it took around 2 hrs and 15 minutes.
No supports, rafts needed. Print with the two arms point up.
I used 15% infill (Grid) and it works well for me. You could increase if you want it to be sturdier and a little heavier.
I printed with 0.2mm layer height, at 75mm/s with combing (within infill) enabled, and it took around 2 hrs and 15 minutes.
No supports, rafts needed. Print with the two arms point up.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
