Thingiverse
spool holder
von reitter_m
39
Downloads
59
Likes
0
Makes
You'll need two bearings:
inner diameter: 10 mm
outer diameter: 30mm
height: 10mm
Mount them on the top and the bottom of the 'middle part' and put everything into the 'screw'.
inner diameter: 10 mm
outer diameter: 30mm
height: 10mm
Mount them on the top and the bottom of the 'middle part' and put everything into the 'screw'.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
