Thingiverse
Spool Holder
von FLX3D
13
Downloads
6
Likes
0
Makes
Spool holder with a adjustable width. Holds PLA / ABS Spools with a hole of a ⌀58mm. (I always use Patona spools)
Additional you need:
Metal Rod ⌀8mm approx. 140mm long (I sanded mine to 7.95 so it's easier to put the ball bearings on the rod)
2x Ball Bearing 608 ZZ (8x22x7mm)
2x Rubber Band to clamp the spool on the 3d printed wheel (PLA Hold)
Additional you need:
Metal Rod ⌀8mm approx. 140mm long (I sanded mine to 7.95 so it's easier to put the ball bearings on the rod)
2x Ball Bearing 608 ZZ (8x22x7mm)
2x Rubber Band to clamp the spool on the 3d printed wheel (PLA Hold)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
