Spool Holder

Spool holder,
sized for eSun rolls but i have included a couple of bosses for other sized holes, the spool holder has a slight tapper on it, so the bosses only fit on one way. You will need some M8 threaded rod and a couple of M8 nylock nuts. One nut presses into the printed wing nut, and the other is to turn the threaded rod into a bolt.
Also 2 bearing from a fidget spinner or you can just draw up and print some plane bearings.
i did this while i was waiting for the fidget spinners and it works fine.
Threaded parts just need a bit of clean up but they will work. The two Printed Bolts are to suit the Ender 3 (square one) and CR-10 (Recessed one) factory Metal stand off.