Thingiverse
Spool Holder
von jlp6k
30
Downloads
16
Likes
1
Makes
Yet another spool holder!
I failed several printings because the filament was not fed properly. So I decided to build my own parametric spool holder.
You'll need to print 4 parts and to provide 2 nuts, 2 bearings and a length of threaded rod. I used M8 screws and skate bearings but you can choose your own as the design is parametric.
I failed several printings because the filament was not fed properly. So I decided to build my own parametric spool holder.
You'll need to print 4 parts and to provide 2 nuts, 2 bearings and a length of threaded rod. I used M8 screws and skate bearings but you can choose your own as the design is parametric.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
