Thingiverse
Spool holder
door dimonick
2
Downloads
0
Likes
0
Makes
Shaft replacement for this design
https://www.thingiverse.com/thing:4600120
I printed with adaptive layer height with 0.2 ± 0.07 mm
But 0.2 should be ok.
Material PETG.
PLA also should be suitable.
ABS probably will not be suitable because of plastic shrinkage.
https://www.thingiverse.com/thing:4600120
I printed with adaptive layer height with 0.2 ± 0.07 mm
But 0.2 should be ok.
Material PETG.
PLA also should be suitable.
ABS probably will not be suitable because of plastic shrinkage.
dimonick publiceert ook op
55 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
