Thingiverse
Spool Holder
von andersborg
1
Downloads
3
Likes
0
Makes
Helps the spool roll easier. To be added to an existing spool holder. Mind the dimensions (measure before you print).
Let me know if you need other dimensions.
Dimensions:
Inner diameter: 38 mm for both
Outer diameter flanges: 52, 60 and 70 mm diameter to fit a range of different spools
Outer diameter spool part: 2 mm less diameter
Tested with:
52 mm: PrimaCreator, Polymaker
60 mm: Sunlu's new spools
70 mm: Sunlu's old spools
Tested on a Creality Ender-3 V3 SE with PTFE tape on the original holder.
Let me know if you need other dimensions.
Dimensions:
Inner diameter: 38 mm for both
Outer diameter flanges: 52, 60 and 70 mm diameter to fit a range of different spools
Outer diameter spool part: 2 mm less diameter
Tested with:
52 mm: PrimaCreator, Polymaker
60 mm: Sunlu's new spools
70 mm: Sunlu's old spools
Tested on a Creality Ender-3 V3 SE with PTFE tape on the original holder.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
