Thingiverse
Spool holder
by moonshinesg
5
Downloads
6
Likes
0
Makes
Needed a simple holder that can be used with different width spools.
Since my printer is fixed on a wooden board, the solution was easy...
(need to cleanup the wires.... but the roll doesn't get near them, so it should be safe)
Uses 2x 8mm rods and 4 x 22mm ball bearings.
(includes STEP file if anyone needs minor changes)
Since my printer is fixed on a wooden board, the solution was easy...
(need to cleanup the wires.... but the roll doesn't get near them, so it should be safe)
Uses 2x 8mm rods and 4 x 22mm ball bearings.
(includes STEP file if anyone needs minor changes)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
