Thingiverse
Spool roller
by Barrocas
9
Downloads
4
Likes
0
Makes
A simple redesign of ianlee74's roller.
Modified dimensions to fit my spools, and added some bearing edge stops on the inside, so the bearings can be pressed in, but remain flush with the outside surface.
This roller is to be placed inside the filament spool, to use in combination with a spool holder that uses an 8mm rod, I used my "Spool Skeleton Mount for Delta Kossel" http://www.thingiverse.com/thing:1740925 with an 8mm threaded rod and 2 x M8 wing nuts.
Dimensions: 31 x 31 x 105mm
It uses 2x 608zz bearings, one on each end.
Prints without need for supports.
Modified dimensions to fit my spools, and added some bearing edge stops on the inside, so the bearings can be pressed in, but remain flush with the outside surface.
This roller is to be placed inside the filament spool, to use in combination with a spool holder that uses an 8mm rod, I used my "Spool Skeleton Mount for Delta Kossel" http://www.thingiverse.com/thing:1740925 with an 8mm threaded rod and 2 x M8 wing nuts.
Dimensions: 31 x 31 x 105mm
It uses 2x 608zz bearings, one on each end.
Prints without need for supports.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
