Thingiverse
Spool support for smartrapcore
von Lyscanthrope
17
Downloads
17
Likes
1
Makes
This is a simple spool support for the smartrapcore.
It work for small spool (tested for up to 750gr but I think it'll work for 1kg).
Just hang on the top of teh smarrapcore. I hanged mine on the right side of it (as I have my extruder outside) and I use a small clip to guide the filament.
Picture of the setup to follow.
All improvement are welcome.
It work for small spool (tested for up to 750gr but I think it'll work for 1kg).
Just hang on the top of teh smarrapcore. I hanged mine on the right side of it (as I have my extruder outside) and I use a small clip to guide the filament.
Picture of the setup to follow.
All improvement are welcome.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
