Spool wall rack

Designed to be mounted with 2 wood screws on each piece printed for the rack. This meant to be used with 1inch wood dowels found at most big box stores but any 1in rods will work. You can make the rack as long as desired as long as you add extra rack holders through out the length(at least every 10 spools).Print 2x of the spool rack mounting helpers to help installation easier.The helpers can be used to mark where the holes will go for the screws just needs to be taped onto the wall temporarily.You can use one of the 1in dowel to connect both helpers on each end and set a level in the middle of the dowel to level out the pieces.Settings used on a k1c-0.2 layer hight witha 0.4 nozzle-10% infill-3 wallsno supports requiredPLA has held up fine for me for 2+ years