Thingiverse
Spoolholder 608 Blocker
von R2G2DE
1
Downloads
0
Likes
0
Makes
The blocker is intended to prevent the part holders from leaving the base and to stop everything from moving towards an enclosure. This could happen when the extruder has to pull too hard.
It will (optically) fit best if you don't use rubber feets.
It will (optically) fit best if you don't use rubber feets.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
