Spoon Holder

Do you re-use a spoon for stirring your coffee, tea, or other beverage? This spoon holder will hold most stirring-sized spoons above the stylish drip tray to keep your counter clean. The opening is 4mm wide which should fit most spoons. I tested it with a teaspoon, a large spoon, and even a flat butter knife. The spoon is held in place due to the higher weight on the end, so as long as the handle is less than 4mm thick and one end is heavier, it should work. If you're unsure whether your spoon will fit, you can just cut off the upper part and print it for testing. If it's popular enough, I'll make a left-handed version! I printed it with 25% gyroid infill. No supports are required, but the area where the drip tray lifts off the bed can look a little messy without a painted-on support. The upper overhang prints fine on the P1P.