Spray Can Holder

If you have bees in the eve vents of your house it is sometimes difficult to reach the bees with an insecticide spray. This device can be attached to an extension pole to hold and elevate the insecticide to the bee's nest. In addition to the PLA needed to print the holder, you will need the following parts:

5 - M4 lock nuts
2 - M4 nuts
12 - M4 washers
5 - M4 x 20mm screws
2 - M4 x 30mm screws
4 - M4 x 22mm screws (25mm should also work)
~30 ft of 1/8-inch nylon cord

I initially printed the holder and threaded attachment as one piece, but soon realized that if I needed different threads or accidentally stripped the threads I would have to reprint the entire device. Therefore there are two parts, one for the holder and one for the threaded part that are bolted together using M4 screws.