Slicer Discord
Spray degasser – 3D printable model from MakerWorld MakerWorld
Other Tools

Spray degasser

0 Downloads
1 Likes
0 Makes
Go to Model
So i normally use hairspray for my beds (in particular a spanish brand, the one with the blue label ;) ), in a roll-on. The first step for doing so would be emptying the can from any gas, which i did using some duct tape in the past.But what is the fun in that? so i created this contraption, which will allow you to fix it to a haispray can (only tested with thie spanish one, not sure if it will fit some others), screw either one of the two plungers (please do this with the can upside down) and leave it overnight for the gas to exit.After that, you should open the can (that i will not provide any explanation, as it might be a little bit dangerous) and they put the liquid hairspray in an empty roll on (you can use Bambu's liquid glue ones, i.e.) and use it
Category
Other Tools
Source
MakerWorld
Published
Updated
What you need to print this: Intermediate Low confidence
Why?
significant post-processing
Single piece Hardware needed
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 2/3
Printer
FDM / FFF
File format
STL
Material
PLA
Post-processing
Gluing, Hardware
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection