Spray Paint Holder - 6 Can (Version 1)

This is the spray paint can holder for holding 6 spray paint cans. This was my first version which is actually very nice still, so worthy of publishing to share. Unique to this design is the mortise and tenon design to hold the 4 parts together. When printed on my P1S and X1C, the parts fit snugly enough to hold well, but still can be forcibly taken back apart if you want to break the holder down again. Holds only 6 cans because thats the most I felt could be printed on 256mm printer bed. I would recommend PETG if you leave this in a hot or sunny area like a garage. My Version 3 design attempts to use less filament and print faster, but at the sacrifice of design. This design is cute as it's a bit easier to pick up and hold if you plan to carry your paint cans around the shop a lot.