Spray paint holder/handle

credit to MiobaD_820988 I wanted to have a little more ergonomic handle. I redraw the model froms crath using the model as reference. I also added a short trigger for one finger and later on a rubber band (just drill 2 holes in each pieces and use standard rubberband) to keep the trigger open.Haven't tested it yet, but I kept original dimensions as close as possible.The trigger is held in by 5mm dowel, but you can use M5 bolt (hole is 5,2mm). I secured the dowel with superglue, will see how long it will last.The can is held in place with M4 bolt with nylon locking nut (I removed the Nylon to be mounted without tools).The settings I chose for this print was pretty standard for PLA+ (gyroid infil 10% and 2 perimeters).I also added 100% infil to the can holder and fuzzy skin to the handle.The ergonomy for me is good, but could be better with more rounded backside in the palm. Maybe I will address this in the far far future. Happy printing!