Slicer Discord
Spring Fin Strap Retention Block – Modelo 3D imprimible de Thingiverse Thingiverse

Spring Fin Strap Retention Block

por lairdb
11 Descargas
14 Likes
0 Makes
Ver Modelo
Do your springs pop off your mushrooms?

(No, not a Mario reference -- I was more of a Colossal Cave type.)


After a couple of years of sadness with the original straps, I finally got springs for my side-post fins*.

(OG Jetfins forever -- but these Oceanic Accel are a lot nicer to travel with.)

So, if you're putting these on side post fins, there's a bolt to keep them from popping back off the mushroom. There's no risk of popping off when worn, but in the bag, or wrassling through the surf or up the ladder, turns out it's possible. Oops!


So, in my typical pattern of overly complex solutions for things that aren't much of a problem, I offer you not just one but two different designs for preventing pop-off.


The first is a space-filler that is locked in place by the retention bolt that's not doing it's job.


The second fills the entire bracket space, and is locked in place by the spring bolt -- theoretically the retention bolt isn't even needed, though you ca
Fuente
Thingiverse
Lo que necesitas para imprimir: Intermedio Baja confianza
Pieza única Tornillería requerida
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 1/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA
Postprocesado
Tornillería
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección