Thingiverse
Spring-loaded track tensioner
door daver18qc
12
Downloads
18
Likes
0
Makes
** Yamaha or Arctic Cat Spring Track Skid Parts **
** UPDATE : **
* March 2nd 2020> Made a Arctic Cat M8000 version
** Infos : **
- Springs are RC4WD internal springs. Z-S1183
- - Dimensions: 5.5~6.5mm_diameter 35~40mm_length
- The promod_rear_sprocket_bearing_v2.stl file is optional but recommended, else the tension will chew through the wheels very fast.
- **Bearings are flanged 3x10x4.**
- Make sure you file/sand the "pushrod" so it can slide freely in the rail's channels.
- Don't overtighten the sprocket screws as it will lock up the tensioner.
- Use 1 small washer on each side between the rails and sprockets for added slippyness.
- Added bonus of having some flex when you jump and land on the tip of the skid!
** UPDATE : **
* March 2nd 2020> Made a Arctic Cat M8000 version
** Infos : **
- Springs are RC4WD internal springs. Z-S1183
- - Dimensions: 5.5~6.5mm_diameter 35~40mm_length
- The promod_rear_sprocket_bearing_v2.stl file is optional but recommended, else the tension will chew through the wheels very fast.
- **Bearings are flanged 3x10x4.**
- Make sure you file/sand the "pushrod" so it can slide freely in the rail's channels.
- Don't overtighten the sprocket screws as it will lock up the tensioner.
- Use 1 small washer on each side between the rails and sprockets for added slippyness.
- Added bonus of having some flex when you jump and land on the tip of the skid!
daver18qc publiceert ook op
34 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
