Thingiverse
Spring onion irrigation system
door Elliworks
0
Downloads
13
Likes
0
Makes
The spring onion irrigation system requires a small bowl. The first picture is an old version.
To fit underneath, the bowl should not be taller than 65 mm and should not exceed a diameter of 140 mm or 150 mm. Two models are available, each with the respective diameters.
The bowl can be refilled with water through the opening in the middle.
Infill: 10-15%
Layer height: 0.2 mm
Supports: no
Material: PLA or PETG
Print upside down
To fit underneath, the bowl should not be taller than 65 mm and should not exceed a diameter of 140 mm or 150 mm. Two models are available, each with the respective diameters.
The bowl can be refilled with water through the opening in the middle.
Infill: 10-15%
Layer height: 0.2 mm
Supports: no
Material: PLA or PETG
Print upside down
Elliworks publiceert ook op
4 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
