Springy Bunny

Small Bunny with springy bodyCan be printed in parts (body + eyes)Inculdes keyring model with optional space for 5x5mm magnet---If you want to sell prints of this model you can write me a message and I will tell you how to get a commercial license---Video:https://www.instagram.com/p/DHaqs1rNkXZ/---Update 08 IV 2025Small fix to base models. I noticed that a part of left ear was cutted offUpdate 17 IV 2025Added Big-gaps versions. Gaps between coils are now 1mm instead of 0.5mm. Also this models are 5mm longerPrint it if coils of a spring happen to ‘fuse’ in printing (usually it's because of stringing or too much flow)---Print settingsPrinted with 0.1 and 0.16mm layer height7% gyroid infill2 wallsMay be harder to print than typical modelsYou will need a good bed adhesion and a good coolingYou may be needed to separate spring coils from each other after print. Usually just with your nails, in some cases with a thin knife (scalpel)It mostly depends on you seam settings and filament stringingIt is recommended to use PrusaSlicer because of the option ‘avoid crossing curled overhangs’If you will have problems with a nozzle knocking out spring parts you can use ADDON_Brim (adding a brim on sides) or even ADDON_Spring-joiner wich will connect spring parts on the bottom with two lines - you will need to cut it with a knife after printADDONs should be merged with base model (except ADDON_ Magnet)For example you can add PARTS_Body, ADDON_Brim and ADDON_Keyring, set it in the same place and merge all three models (right click menu)If you want a magnet inside add a 'negative volume' and select ADDON_Magnet_5x5mm or add a cylinder with proper size (0.1-0.2mm bigger than magnet)Also you will need to add a pause - usually on the first layer where the magnet hole is closing---