Thingiverse
Toys & Games
Zum Modell
Springy Flower Fidget
236
Downloads
875
Likes
1
Makes
This is a fairly easy print springy flower fidget.
See the full collection here: https://www.thingiverse.com/thing:6782495
The flower screws into the stem and the stem screws into the springy dirt. The dirt snaps into the flower pot.
No supports are needed but use an 'outside only brim' on the flower and stem. Do not scale down the model or the threads might get too tight.
The model shown was printed with ABS using a .12mm resolution.
Please like and upload a make!
See the full collection here: https://www.thingiverse.com/thing:6782495
The flower screws into the stem and the stem screws into the springy dirt. The dirt snaps into the flower pot.
No supports are needed but use an 'outside only brim' on the flower and stem. Do not scale down the model or the threads might get too tight.
The model shown was printed with ABS using a .12mm resolution.
Please like and upload a make!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
