Sprite-Cable-Hanger and Clip

I don't think this published properly out of Tinkercad so publishing again via Create/Upload a thing option.

This is a flat cable hanger and clips for a Creality Sprite Pro extruder. The hanger mounts in the back top rail of an ender 3 pro or any printer actually and it helps not bend the cable as much as no guide does.
Position the guide to make sure the extruder has full movement then lock it in with a rail nut. See rear picture
The clips are to hold the BL Touch wire flat to the ribbon cable. Not sure if they ever fixed it but when I got the Sprite Pro about a year ago the flat cable that breaks off to the bl touch did not work and the solution was to use the original wiring. So hence the clips.
Been using for a week now and it does seem to take the stress off the ribbon cable where it plugs into the extruder