Thingiverse
Sprite Pro Probe Z-Offset
door Buschy
0
Downloads
2
Likes
0
Makes
VERY Basic - BLTouch - Z Offset for Creality Sprite Pro.
Prints fast
Requires xtra Hardware (Nuts and Bolts or Screws)
See Photos
-40; -40.5 was my new offset.
The Probe Tip is WAY too close to the bed if you use the Sprite Pros intended mounting point, and it will snag on Prints.
I mean, I couldn't even do the Paper Tramming thing without it snagging on that dang Probe.
So, I finally got tired of it, and designed this... Mounting Bar Extension!?
Prints fast
Requires xtra Hardware (Nuts and Bolts or Screws)
See Photos
-40; -40.5 was my new offset.
The Probe Tip is WAY too close to the bed if you use the Sprite Pros intended mounting point, and it will snag on Prints.
I mean, I couldn't even do the Paper Tramming thing without it snagging on that dang Probe.
So, I finally got tired of it, and designed this... Mounting Bar Extension!?
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
