Thingiverse
Spritz Cookie Dies
door Joe_Snuffy
56
Downloads
42
Likes
0
Makes
Was bored and wanted some new shapes for my cookie press. One can handle only so many Christmas trees. I ended up making four, though the helicopter one is mostly a fail. The M. Falcon and R2 unit come out pretty good with one and a half squeezes. The Hashtag works fine.
They are designed to fit my Wilton Cookie Pro Ultra II. I'm pretty sure they will fit most cookie presses made in the last ten years.
11/11/15 Redesigned the helicopter die. Not perfect, but, it resembles one a little better.
02/18/19 Someone asked me to try and design a Sea Turtle. There were a few redesigns after absolute failures. I've posted the two that seem to look the best for me, I tend to make a stiff dough when I make these cookies. I think if I had had Design 4 ready when I made the cookies with Design 3 they would have looked better. The dough sat at room temp for over an hour while I redesigned and printed #4, so it was a bit softer. Let me know if y'all have any luck with these. D
They are designed to fit my Wilton Cookie Pro Ultra II. I'm pretty sure they will fit most cookie presses made in the last ten years.
11/11/15 Redesigned the helicopter die. Not perfect, but, it resembles one a little better.
02/18/19 Someone asked me to try and design a Sea Turtle. There were a few redesigns after absolute failures. I've posted the two that seem to look the best for me, I tend to make a stiff dough when I make these cookies. I think if I had had Design 4 ready when I made the cookies with Design 3 they would have looked better. The dough sat at room temp for over an hour while I redesigned and printed #4, so it was a bit softer. Let me know if y'all have any luck with these. D
Joe_Snuffy publiceert ook op
26 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
