Sprung Buffer set for 1:32 scale trains.

Please note the slot where the buffer housings I also offer for these that fit onto buffer beams are .325 inches in diamter, roughly 8.255 millimeters for those who use the metric system. The tail where the spings go over and give the buffers the spring effect is .115 inches in diameter and .645 inches long, roughly 2.921 millimeters in diameter and 16.383 millimeters long.

How to assemble.

1. print the buffer heads and the buffer housings.

2. Slide the spring onto the buffer heads' tail and put it in the buffer housing.

3. use galvanized wire to tie onto the end of the buffer head's tail to prevent the buffer head from flying out like a Nerf Dart.

4. Now you can glue the buffer on, I recomend hot gluing it on incase the buffers break and need parts replaced.

The springs you'll need must be 5x0.4x15mm, which you can easily find on Amazon.

you'll need wire to lock tie the buffer heads to their housings roughly a millimeter in diameter, I recomend galvanized wire you can easily pi