Thingiverse
SPST switch mount
von ShopsmithVsEvil
2
Downloads
3
Likes
1
Makes
I needed some way to hold some switches that control the LEDs on a 3D printer enclosure I'm working on. I came up with these that take standard 125VAC SPST switches. You melt the little tabs down with a hot knife or similar and it fuses the switch to the mount (if you rotate the model around you'll see them, I don't know why it displays the way it does here). Mount is mounted with 2 10-24 screws (or other 3-6mm major diameter screws).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
