Thingiverse
Spudger (fixed)
door sej7278
105
Downloads
43
Likes
1
Makes
Ran through Netfabb to fix the STL.
Its still a bit too thin to print well with the supports. Might make one with a totally flat edge on the bottom
Its still a bit too thin to print well with the supports. Might make one with a totally flat edge on the bottom
sej7278 publiceert ook op
27 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!