SQFMI Watchy Case

This is a case for what's advertised as "Watchy smartwatch" and what is a rip-off from here to Alaska and back again. Anyway, I wasted $55 on that devkit that doesn't even come with basic functional firmware, and is too fragile to tinker with, so I had to make a case before I can start hacking on it.

The case is still Work-In-Progress (and might stay so), but it should fit the watchy hardware inside. There are three pieces to the case (fourth one is under development):

* CaseBottom.stl - print as is. This is the bottom of the case, the battery goes there, put a little piece of foam (or even 2x3cm cutout from a kitchen towel) over the battery to cushion it against the PCB that will come on top.

* CaseMidFrame.stl - print it on its top surface, the eInk display comes to rest on it. You will have to unplug the display from the PCB to assemble this.

* CaseTopFrame.stl is the display frame, print it laying on its top surface, you may need some supports for the corner holes. If y