Thingiverse
Square Drain Pipe Lid
von TotalRetribution
4
Downloads
5
Likes
0
Makes
This is an end Cap and Lid Mechanism for 65mm Square Drain Pipe.
It requires either some m3 threaded rod or m3 screws with an length of 40mm.
It also requires a small Torsion Spring bent as per the photo. The spring must allow the m3 rod/screw to fit inside.
It requires either some m3 threaded rod or m3 screws with an length of 40mm.
It also requires a small Torsion Spring bent as per the photo. The spring must allow the m3 rod/screw to fit inside.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
