Square Rotating clock

Print instructionsI modified the design so it would fit this specific clock mechanism. I scaled it up to about 25cm, so the clock is a nice addition to to your room without looking small. It printed fairly easily on my Bambulab A1 however, I definitely needed the brims for the hour and minute prints to get good bed adhesion. I decided to print with fuzzy skin, and used the paint fuzzy skin tool. I also decided to print with very thin layer lines. This made the quality look good, however, printing will take a while. Make sure to let the bed cool down before removing everything so all the squares stay square. Post-PrintingAssemble in this order:Screw the movement on to the flat facePress the hour hand onPress the minute hand onAdd the metal cap over the shaft, if your movement has oneSnap the flat face into the frame