Square tealight mold

This is made to fit the standard tealight we have here, it might not fit yours.

IMPORTANT: There is a couple of steps you need to do to successfully produce a "square" candle.
First clean the inside of any stringing and sand it smooth. Proceed to apply a little bit of WD-40 and make sure it is spread evenly.
Then remove the wick of a tealight, seat it in the small circle inside and seal it with a little bit of wax.
Once you have made sure no wax is leaking through the hole underneath you can fill it up completely and place it in the freezer to cool.
When it has become solid it will have shrunk a little so it is easier to insert something from the bottom like a piece of wood to push out the candle, and you are done.

You might want to get a square tealight holder for this :)