Slicer Discord
Squid pole top spike – 3D-Druckmodell von Thingiverse Thingiverse

Squid pole top spike

von vk3ohm
4 Downloads
4 Likes
0 Makes
Zum Modell
Radio amateurs use squid poles to hold up antennas for portable operation. The heavy duty squid poles (Haverford) have a spherical ball on the tip. This is difficult to attach an antenna to. This tip fits snugly over the spherical ball and provides a threaded spike that can be used to restrain the center of a dipole antenna.

This is an updated version of the original. I found that the threaded spike on the end wasn't strong enough, so I have replaced it with an M6 x 25mm Nylon bolt and nut.

There are now 2 versions. The _short variant is less tall which helps to allow the squid pole bung to fit.
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA, Nylon
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen