Thingiverse
Squirrel Cage Fan MK1
von bbo
13
Downloads
14
Likes
0
Makes
Print specs
2 shells
15% infill
no support
Material PLA
Material for high heat applications PC-ISO (Polycarbonate Iso or Ultem)
This part was originally printed in PLA with 2 shells and 15% infill as a tester the PLA it can be used for low temperature applications (PLA will not hold up to high heat applications). This squirrel cage fan was installed in a bathroom the fan is next to a heat lamp and the failure mode is documented above. The final part was printed in PC-ISO (Polycarbonate Iso not Ultem) on a commercial machine
Final part settings:
PC-iso
Fortus 400mc
Solid Fill
Dissoluble SR-100 support
0.010in layer height
Time: ~10 hours
2 shells
15% infill
no support
Material PLA
Material for high heat applications PC-ISO (Polycarbonate Iso or Ultem)
This part was originally printed in PLA with 2 shells and 15% infill as a tester the PLA it can be used for low temperature applications (PLA will not hold up to high heat applications). This squirrel cage fan was installed in a bathroom the fan is next to a heat lamp and the failure mode is documented above. The final part was printed in PC-ISO (Polycarbonate Iso not Ultem) on a commercial machine
Final part settings:
PC-iso
Fortus 400mc
Solid Fill
Dissoluble SR-100 support
0.010in layer height
Time: ~10 hours
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
