Squirrel feeder Scrat

Needs support enforcer under hinge ring on body.
May need some support for the nose.
3mm pin is small so it rotates easily. maybe a bit thicker would also work. Glue in place when assembled.
The lid can be opened and stay open.
The feeder was tested and squirrels can open the lid and get the nuts. However it can be a bit deep for them to get small nut pieces from the bottom.
I've added a slot for a rectangular magnet to be put in. You should instruct the slicer to put a pause in at 4.68 by gcode M0 so you can put a magnet in. Or just leave it and let it print it without magnet or pause.
The neus-v4 is a better nose. Please use this one. Make sure to secure the pin with some glue or m3 nut&bolt because the squirrel in our garden took the nose with him after removing the pin.. :(