sram brake matchmaker clamp

This is a https://www.thingiverse.com/thing:4172914 remix, increase 1mm, fill in the circumference so that it fully insure on the handlebar for better tightening. I also eliminated the excess on the tips, because it touched the brake before achieving the tightening.

Files: .stl and .3mf are two format of same piece.
.gcode its for download and print directly from sd-card.

Layer Hight: 0.16
Wall Thickness: 1.4
Wall Line Count: 3
Infill: 70% (maybe can be less, i tested with that)
Infill Pattern: Cubic Subdivision
Printing Temp: 196º
Plate Temp: 45º
Print Speed: 50mm/s
Material: I used PLA but think the best for this is ABS.
You need also: M6x30mm screw and nut

I used "Custom Support Cylinder" Plugin to put square 4x4mm support only in the center of both holes.