Thingiverse
SRAM DUB cap tool
door bentmettle
10
Downloads
6
Likes
0
Makes
4 pin spanner to use with an 8mm hex to remove SRAM dub cap, or tighten it.
I used a spoke cut into 19mm long sections to press into the holes. Cut the spoke with a cut off wheel and chamfer the edges so you can get it started into the small holes. Close between smooth vice jaws to set all the pins to the same depth.
added a version to use with a chainwhip or 1" wrench - use 10mm long lengths for pins for that one.
I used a spoke cut into 19mm long sections to press into the holes. Cut the spoke with a cut off wheel and chamfer the edges so you can get it started into the small holes. Close between smooth vice jaws to set all the pins to the same depth.
added a version to use with a chainwhip or 1" wrench - use 10mm long lengths for pins for that one.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!