Thingiverse
SSD Caddy Jonsbo N3
von freddysh
14
Downloads
35
Likes
0
Makes
This is a caddy that enables the use of SSD in the Jonsbo N3 NAS case. I think it should also work in the N2 case.
It is a tight fit, this is required as it is only friction that holds it in.
The SSD is retained by 3 spigots and optionally an M3 screw (I found that the screw was not required however the design includes a provision for one)
The design was made in Tinkercad and is publicly accessible on that site for remixing (search for Jonsbo, there are not many others)
It is a tight fit, this is required as it is only friction that holds it in.
The SSD is retained by 3 spigots and optionally an M3 screw (I found that the screw was not required however the design includes a provision for one)
The design was made in Tinkercad and is publicly accessible on that site for remixing (search for Jonsbo, there are not many others)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
