SSR Cover

It is only .1 mm larger on each side than my Fostek SSR 25 DA. The fit is very snug but doesn't require a lot of force to slip it on. This should fit if the dimensions of your SSR are or slightly less than 44.9mm x 59.9mm x 11.1mm.

Also, apologies but you will have to flip the model top-side down to print it.

Setting I used may be a bit too dense but it is just the recommended settings for Voron parts, and I didn't change them. You can probably decrease everything but I do suggest using a filament that can handle heat as SSRs can get hot, so PETG, ABS, ASA. I printed my in Bambulab ABS.