Thingiverse
SSR DIN Clip
von chaddavisdesign
62
Downloads
36
Likes
0
Makes
One of the very common heat sinks for SSR modules slides onto a DIN rail, but very loosely with no means of tightening it. I added a wedge to a rail clip to fill the gap on each side and secure the heat sink to the rail.
On the rail place a clip on each side of the heat with the wedges facing the heat sink. While holding the three pieces secure the clips with an M3 screw 6mm to 10mm in length.
OpenSCAD source file included.
On the rail place a clip on each side of the heat with the wedges facing the heat sink. While holding the three pieces secure the clips with an M3 screw 6mm to 10mm in length.
OpenSCAD source file included.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
