Thingiverse
SSR Mount
von Treeda
3
Downloads
0
Likes
0
Makes
if you can't mount an SSR directly and want it with smaller screws, here's a mount for you.
Below the SSR is a bit space so it can get warm a bit but take care of the printing material if your SSR gets hot.
SSR gets mounted with 2 x M4x12 and M4 Nuts (length depends on your SSD), fits normal 60x45mm SSR
The Mount itself is prepared for M3 screws
Below the SSR is a bit space so it can get warm a bit but take care of the printing material if your SSR gets hot.
SSR gets mounted with 2 x M4x12 and M4 Nuts (length depends on your SSD), fits normal 60x45mm SSR
The Mount itself is prepared for M3 screws
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
