Slicer Discord
Stable funnel with screw cap – 3D printable model from MakerWorld MakerWorld
Other Hobby & DIY

Stable funnel with screw cap

15 Downloads
4 Likes
4 Makes
Go to Model
English:Are you tired of putting your funnel in a cup after use so that excess liquid doesn't drip onto the floor?That's over now, because this funnel has a screw-on lid.Now you can easily hang your funnel on the wall without anything leaking.Excess liquid now collects in the lid, which you can easily empty before next use.The inner diameter of the funnel in the upper area is 11 cm.Deutsch:Sind sie es auch leid ihren Trichter nach der Benutzung in einen Becher zu stellendamit überschüssige Flüssigkeit nicht auf den Boden tropfen kann?Damit ist jetzt Schluss, denn dieser Trichter hat einen schraubbaren Deckel.Nun können sie ihren Trichter problemlos an die Wand hängen ohne das etwas auslaufen kann.Überschüssige Flüssigkeit sammelt sich nun im Deckel, den Sie vor dem nächsten Gebrauch einfach entleeren können.Der Innendurchmesser des Trichters im oberen Bereich beträgt 11 cm.
Category
Other Hobby & DIY
Source
MakerWorld
Published
Updated
What you need to print this: Intermediate Low confidence
Single piece Hardware needed
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 1/3
Printer
FDM / FFF
File format
STL
Material
Post-processing
Hardware
Software
Cura, PrusaSlicer, or similar
Same designer, more platforms

NxtGnPrtHub also publishes on

7 additional models across 1 more platforms

Verified by matching model titles across platforms.
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection