Thingiverse
Stackable Hydroponic Planter
von Raspbian
2
Downloads
2
Likes
0
Makes
This is my design for a hydroponic seedling starter. This design goals:
1. Based on Aerogarden pod size.
2. One plant.
3. Pots can be connected together on two sides.
4. LED Light can be connected.
Because of the way 3D Printing works, the bottom of the pot is literally a sieve. It must be coated with a food safe epoxy, such as Artesian.
The LettuceGrow pods are too big for this planter. Perhaps a later version will be just a bit bigger.
LEDTower is coming.
1. Based on Aerogarden pod size.
2. One plant.
3. Pots can be connected together on two sides.
4. LED Light can be connected.
Because of the way 3D Printing works, the bottom of the pot is literally a sieve. It must be coated with a food safe epoxy, such as Artesian.
The LettuceGrow pods are too big for this planter. Perhaps a later version will be just a bit bigger.
LEDTower is coming.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
